Return Air Duct Attic

Return ducts in my attic.

Return air duct attic.

A return air temp b outside air temp c airflow across evaporator coil d return air leaks from attic if you measure supply and return temperatures at the grille and at the air handler you can get an good idea of where your biggest losses are occurring. That s right your heating and air system is nothing more than a big circulation unit. Install the damper into the duct by drilling a hole into the side of the duct and then screw the damper into place. Air handler platforms used as return air plenums can draw air from vented attics and crawlspaces through other connected framing cavities.

The damper control indicator will show you whether the damper is open or closed. I ve replaced the supply ducts and have insulated and encapsulated my crawlspace according to the best methods presented on this site. If the supply ducts are high or in the ceiling then the return air ducts or grills should be low on a wall. The unconditioned space also houses his hvac system.

Openings shall not be located less than 10 feet 3048 mm measured in any direction from an open combustion chamber or draft hood of another appliance located in the same room or space. A return duct is the part of the system that carries the air back to the furnace or air handler where it will then be circulated back out through the supply vents. My 1948 ranch house has supply ducts in the crawlspace return ducts in the attic. Not providing enough returns is a common ductwork design flaw that leads to comfort complaints.

Without the return duct the air in the home would not be able to properly circulate. The return air vent openings need to be on the opposite side of the room so the conditioned air is pulled across the room. At 21c i d guess you have a lot of leaks on the return side. To maintain balanced air pressure and air movement your duct system needs return vents for air in the room to be pulled back into the hvac system.

If the supply ducts are in the floor then the return air should be located up high. While none of these spaces makes an acceptable air pathway on its own some building cavities such as floor joists can make acceptable duct chases to contain an insulated air sealed metal or flex supply or return duct. The ducts through which the air travels are part of a sealed system that usually is located in the attic for structures with slabs or under the floors on structures that are raised off the ground. Put the crimped end in first then put the other end of the duct in.

Ted has more than a few cobwebs in his attic. In the summer the return duct removes warm air from inside and transports it to the outside to be conditioned. I have a couple questions. This pulls the air across your body.

The takeoff rotates to make it easier to fit the duct into place.