Revit Roof Ridge Line

How to create roof ridge caps and roofing sheets in revit models in a simple way.

Revit roof ridge line.

I want the ridge to align with the column that is slightly to the left. For this we have to change the height of the right eave using offset from roof base at a negative value. How to create roof ridge caps and roofing sheets in revit models in a simple way. This tool is located in the modify tab.

In this video we will be creating a roof ridge tile using the revit fascia tool. Note that you can place the ridge exactly where you want it. When you are sketching the roof revit assumes all lines of the sketch are at the same height. Example 2 roof by footprint with different slopes on of 30 degrees and one of 50 degrees.

It is a matter of geometry. Use it to extend the dormer roof to the main roof. I ve attached a image of the elevation you can see the gap in the beams where i want to move the roof ridge. Use join unjoin roof tool.

9 join roofs add opening to create dormer. The tiles are nested into a line based generic family and arrayed with constraints to the beginning and end. To fix your roof select the edge of the roof that is lower in the sketch of the roof. We want to move the ridge by 1 50 meters to left.

The footprint is fine and i want the slopes to be based off of the ridge location and wall height not manually entered as i dont know what they will end up being. Then follow these 2 steps. Edit the roof sketch double click the roof or select the roof and click modify roofs tabmode panel edit footprint or edit profile. After creating a roof you can change its shape or overhang cut openings or align ridges.

If you want to change the position of the roof use the properties palette to edit the base level and offset properties to change the position. Then you pick the tool that looks like a dot with up and down arrows to specify the height above the base level you want the ridge at. Start with a flat roof then highlight the roof then in the options bar you will see various buttons on lets you place points on the roof the one that looks like a line lets you draw a ridge line. To create a dormer model required walls and additional roof.

Micrographics https www mgfx co.