Removing Carpet Nails From Hardwood

After pulling up your carpet you will most likely have tack strips left around the perimeter of the room.

Removing carpet nails from hardwood.

In order to have that beautiful hardwood floor you need to keep in mind that there are two types of glues that are used when putting down a carpet general carpet adhesive and tar based glue. This needs to be removed. On a concrete floor the carpet pad is often glued into place. Remove all of the leftover residue.

Step 1 start in a doorway or corner of the room. The procedure for removal of both these adhesives is the same but the products used are not. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. In this case use a floor scraper to remove the pieces of padding that remain stuck to the floor.

You ll be relieved to learn it s a straightforward task to remove carpet tack strips from hardwood floors. Joe is still working on his carpet removal project it s now. Tough spots might require a power oscillating tool. Locate a nail head on top of the tack strip.

Dispose of tacking strips and any staples or nails that held the strips in place. Use your standard screwdriver to pry them from the floor. Use the pliers to pull up any staples that remain stuck in the floor. If the old carpet was installed over a hardwood floor that you now want to restore slide a wide putty knife between the tack strip and the floor.

Repairing carpet strip holes in a wood floor. If you ve pulled up an old carpet to reveal a hardwood floor there s a good chance the floor will need some level of repair. Use pliers to pull padding staples when removing carpet from stairs. Step 2 locate the brad nails that hold the first piece of tack strip to the floor.

Before you can begin to deep clean hardwood floors you will need to remove the stubborn adhesive that was left behind you might also still have some remnants of your carpet tacks and staples still on the ground that need removing.