Remove Carpet Tack Strips From Hardwood

Getting rid of tack strips.

Remove carpet tack strips from hardwood.

The tackboards run continuously in four rooms 12 tacks per foot of board and the tack heads seem to have been embedded into the concrete when the house was built the pointed heads are up instead of down in the concrete. After pulling up your carpet you will most likely have tack strips left around the perimeter of the room. Taking a carpet tack strip off of a concrete floor will be somewhat different from taking it off of a hardwood floor especially if you plan on keeping and restoring the hardwood floor. Joe is working on a carpet removal project now he is ready to.

Since these tack strips are nailed into the floor there will be small holes in the floor when you are done but it is important to cause as little damage as possible in the process. Sweep the entire floor as soon as the tack strips have all been removed. I ripped my carpet out which revealed lots of tack boards attached to the concrete slab underneath the carpet. 3 inch putty knife to place under the pry bar when removing the tack strip to.

This will avoid damage to the hardwood floors from grit and debris trapped beneath the tack strips. Repairing carpet strip holes in a wood floor. Some stairs have carpeting that runs up the center with edges that are bare hardwood. Typically there are three evenly spaced brad nails which are used to hold every three feet of tack strip in place keeping this in mind you want to start from the corner of a room and work your way inwards.

Using the curved edge of a pry bar line it up with the first brad nail and gently slide it under the tack strip. If you ve pulled up an old carpet to reveal a hardwood floor there s a good chance the floor will need some level of repair. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish.