Remove Carpet Runner From Stairs

Pull the carpet back from an upper corner so that you can position the pry bar or crowbar behind the piece of carpet.

Remove carpet runner from stairs.

If it is cut it with the utility knife about an inch down from the top of the riser. Pull all the carpet and use adhesive remover on what s left. Removing stair carpeting step by step. How to remove the carpet from your stairs we had builder grade runner that was showing its age our house is 11 years old with oak treads underneath.

So here is the project replace carpet with stair runner tutorial. Note that many installations will have a separate piece of carpet pad to remove for each stair. If both the treads and the risers are carpeted you may be able to slide the blade of a utility knife along an edge without scratching the wood. No remover on the carpet itself that will just make a mess and waste product.

Removing carpet runners that have bar rods and floor clamps is much easier although you might need to remove adhesive as part of the process. First inspect the carpeting on the top stair riser to determine if it s part of the landing carpet. Wear proper safety gear such as safety goggles or glasses gloves and a face mask to avoid cuts flying debris and dust while removing the carpet. Ripping off the carpet and painting the stairs was the best decision i made.

Once you get the carpet up this is what you will see. The hardest part about removing carpet from stairs is starting. How to remove a carpet runner. When a runner is loose worn and dirty.

And like i mentioned if i had any delusions of something nice lurking beneath this mess of carpet that was quickly put to rest after the first couple of stairs. The blue stuff is the carpet padding and the arrows show where the nail strips are. If you don t have hardwood stairs under your carpet we have a great tutorial on that process here. Carpeted stairs consist of a carpet pad nosing tack strips tread riser and carpet.

Inspect the stairs after the carpet is removed and the runner pad that may remain. Use the flat head screwdriver or pliers to remove tacks and staples holding the runner pad in place. In fact it just got worse as i went down the stairs ripping that carpet and padding off. Step 1 get started.

The runner is probably stapled brad nailed to the wood steps just under the rounded lip of the tread and at the bottom of each riser if there s no padding underneath. Simply unscrew the clamps at the juncture of horizontal and vertical and place the rod assembly in a safe place. Without damaging the wood you must reach under the carpet and pry it free. I started with the bottom step by using pliers to pull carpet away from stairs.