Remove Baseboard To Install Carpet

Removing baseboards for these projects will prevent the trim from being partially hidden by new laminate and it will make carpet installation much easier.

Remove baseboard to install carpet.

This is generally about an inch for the nail tack and you will use a carpet tucker to tuck the excess carpet into the baseboard. Baseboards do not need to be removed. To install hardwood it s. The carpet installer can run the tack strip up to the trim then roll excess carpet under the trim.

Take it from a 31 year professional installer put down the baseboards first leaving a gap at the bottom for the very best. There are a few benefits to removing the baseboards before installing wall to wall carpeting. 1st someday you will be replacing the carpet if you have the baseboards installed on top of the carpet you will have to remove them to pull up the old carpet. In my house they had to go from carpet to tile and lino.

When installing carpet after the baseboards are in place there will usually be some instructions that tell you how far you need for both the carpet pad and the carpet itself. Over time or with a lot of foot traffic carpets can pull. Installing new floors yes remove. Therefore you do not have to raise the baseboard if it was installed with normal space underneath for carpet installation typically a piece of scrap plywood or subfloor or baseboard is used as a gage during installation so you see 3 8 and 1 2 space commonly although i have seen as much as 1 which is too much for most carpets.

Then the cuts are tucked between the tack strip and baseboard for a finished look with a putty knife. Use a utility knife to slice any caulk that secured the baseboard to the wall. Number the walls and corresponding sections of baseboards to easily match them up later. How to remove baseboard to install carpet.

The tack strip is nailed around the perimeter of the room right along side the base board. For most installers this is not a problem and can be done easily. In addition the tack strip will be under the baseboards. Remove the baseboards the day before the flooring installation so you can move furniture away from the walls.

The baseboard goes in first always the carpet installers don t like this if they have to install new thicker baseboard for the customer they have to remove the old tack and install new this is very time consuming and their usually on piece work. The carpet is attached to the tack strip stretched and cut along the tack strip. For hardwood the flooring is installed first and the base sits atop the flooring.